The FBM – T1 Temperature Controller is an in-line thermostat which allows air temperature to be precisely maintained.

• Easy installation Plugs into a power cable
• Easy programming Simple push button entry
• Duel voltage Available as 230v or “site safe” 110v

The FBM – T1 is specifically designed to maintain a consistent air temperature. This may be in a “high temperature” environment or maintaining a temperature within the “comfort zone” of people at work or rest. It can be used to maintain a nominal air temperature to protect equipment, etc. from the type of damage normally associated with cold and damp.

It may be used to “switch on” or to “switch off” any device connected to it and requires only simple programming to enable it to work in a 0 – 100°C temperature range.

Typical applications for the T1 might include the protection of temperature intolerant materials when subjected to a drying or sterilising application. The FBM – T1 is connected between the power cable and the appliance (or between two power cables to the appliance); it is positioned where the desired temperature is needed i.e. inside a machine or sensitive area.

————————————————————————————————————————————————– To discuss the FBM T1 and it’s benefits to you, contact us now ————————————————————————————————————————————————–

 

The FBM – HC Humidity Controller is an in-line sensor and switch which allows the air to be held at a specific humidity. It can be used to turn off dehumidifying and heating equipment or to turn on humidifiers and foggers etc.

• Easy installation plugs into a power cable
• Easy programming simple push button entry
• Duel voltage available as 230v or “site safe” 110v

 

FBM – HC is designed to maintain a specific humidity within a controlled zone or room. It may be used to maintain a programmed RH value to protect equipment etc from the type of damage normally associated with cold and damp i.e. to hold a RH value no higher than 65%

It may also be used to protect materials (wood), reptiles and plants etc from dehydrating i.e. to hold a RH value no lower than 50%. It has a simple programmable control allowing it to work from 0 – 100%.

The FBM – HC is connected between the power cable and the appliance or between two power cables to the appliance and it is positioned where the humidity control is needed. It may also be used to provide a visual record of humidity in a display case or similar.

 

————————————————————————————————————————————————– To discuss the advantages of the FBM HC, contact us now ————————————————————————————————————————————————–